I like how you used Energon pieces to make the neck assembly. (It is Energon, right?)

<{POST_SNAPBACK}>

 

Nope.  Just styrene and the neck from Swindle.  The whole part swings down and puts the head behind the dash.  Really similar to Swindle but mounted a bit different.

<{POST_SNAPBACK}>

 

 

That's a custom piece? That's really clean.

That is so much better than Swindle!

*drools*

I am continuously amazed by the amount of skills you have

cant wait to see it finished :thumb

Are you gonna make new engine pieces for  the back of the arms due to the truck having a different engine type???

OMFGWTF!@!!!!!!!!!!!!!!!!!!!

 

 

i'm amazed with this piece...... Masterpiec i must say

 

 

damn dude

 

sell it to me please!!!!!!!!!!!!!!!

Beautiful!

Another quick Update.

 

I mentioned before about having to make a connector piece for the waist becasue the truck wheel base is a lot longer than the jeep.  Here's how I did it.

 

I made a custom piece out of styrene that would connect the two parts of the waist.  I made it so it would slide along the top part of the waist.  It works fine and save it having to be a partsformer.  The only drawback is that it slides up into the chest and it will limit the waist articulation. 

 

Here's the original piece and the custom piece.

 

 

Here's it on the truck.

 

 

And here's a run-through of the transformation.

 

 

Thanks for the compliments everyone!