Upgrades

first off an alternate transformation for alt swindle/hound just unfold his waist joint, this allows the jeep hood to angle down, it gives a skidz feel and ALT Punch And Counterpunch

Grimmlock pmed me the other day asking me to digi paint Alt Optimus into an Alt Ultra Magnus. So I figured I`d give it a try and while I was at it I`d digi paint a Rodimus Prime version for those of you who want to see how Alt Optimus would look in Roddy`s colors. It`s not as good as my BT Rodimus Prime but it`s not too bad. First Alt Ultra Magnus. Unfortunately I had to go for the no armor version even though if they do release a white repaint of Alt Optimus as UM I`m definately going to build and armor. I`m thinking a car trailer that will fold over his chest and well I`m still trying to think of the rest of it but it`ll be cool. Up next is Alt Rodimus Prime. …

Hey everyone, You know how Omega seems a little to..... short.... Well, I think I had figured out a slight mis-transformation to make him a bit taller. For those of you that have G1 Omega, you might know what im talkin about when i say this. All you have to do is when you transform him into bot mode is leave all the grey colored track peices together. There are four diferent peices on each leg, ok. the 2 large ones that make up the normal legs, and the 2 that connect the tank treads to the feet so that he can walk around. The treads still connect to the 2 smaller track peices, and the feet just kinda... well... sit there, but it makes him look that much better. I'll get s…

OK, I want to make shields out of my Viper hoods, but I need help figuring out the best place to cut the little hinge piece so the hood comes off but is still secure in car mode. I will not be adding a handle directly to the inside of the hood; instead I'm working on a clip-on piece that will have the handle attached, that way for car mode I just pop the clip back off and fit the hood back on. Any ideas?

I just finished these the other day. i molded these fingers from discarded rubber pieces from the forklift from my warehouse. i think they turned out pretty well. i finally found a use for those horrid twist ties, they are the middle connectors for the articulated fingers. i tried to get close to show accurate as i could. what do you think? :thumb

Well, I'm gonna attempt my first kitbash. I've done a few repaints and paint real cars so that's not too hard haha. It's alot easier making custom pieces on such a large scale so this should be a real challenge. I'm posting this from my laptop so no digibash yet, but I bought this 2005 C6 Corvette, and I'm gonna try to fit the body over an existing Tracks mold. I don't really wanna start on this yet, because I only have one Tracks and don't wanna screw him up if I can't find another. Anyone else tried this/thought about it yet?

I was just noticing how boring and plain E. Grimlock's whole torso section was (all that yellow), and I decided to change it up a little with some red and black. Before After Comments? Thoughts? I'd love to hear them.

with a bit of kitbashing the guy could make for a decent hotspot or onslaught for that matter. this guy could go either way in vehicle mode am i the only one who sees the potential in this figure?

Not sure if this was posted before, but here goes: http://www.tfclub.com/tftop/diy/200502030001.shtml I think this is an awesome idea.

I found this isn't an original idea, but it is pretty logic.