I've had my Camarobee for awhile now, found him on the shelf, of all places, in Canada (yay less scalping).

Anyway, he's awesome, except for this one thing that constantly bothers me: These little yellow panels that go on his shoulders, presumably to break up the black arms, don't really have anything affixing them to the arms. They fit on into the grooves of the ball joints, but they pop off at the slightest notice, and I basically have to remove them to put him back in car mode, as they inevitably pop off fitting the arms into the car body.

So, just to confirm, A) does every figure have this, or is mine just missing some adhesive/incorrectly molded?

and b) as someone who has never kitbashed anything ever in his life, any suggestions on fixing it? I'd rather have them stay on, they do make the arms look better.

Everyone has this problem, it isn't just you.

Personally, I just took the smallest dot of superglue to the tab that fits into the slot on the shoulder. Obviously a very small amount will work, and too much will cause the shoulder pad to glue to the ball joint, something you want to avoid. Since then, no problems at all.

Pop the arm off and superglue.. That way you can use as much as you feel necessary and not glue the shoulder.. Took me only 2 transformations to glue them after loosing patience..