This is my first post, thx to see ^^





This Osman Prime's design is excellent, and it has the best look and the most traditional desgin. However, the space between the car front and the bumper is too large; that's the largest flaw. Therefore, the main point is to thicken the arm section in order to narrow the space.

After that, changing the leg part to make it able to stuck into the thigh. This will make the outlook of the truck much better. In addition, during the changing of the leg part, I found out the orginal design has set the strinking design as default. It has been cancelled and it might due to cutting the cost, so it makes the changing much easier.

The haed part is so close to the chest, and it is unable to allow the head to pull back. However, this part is easy to modify.

I played a lot after the modification since it's transformation is easy. I made some scratchs on the lower part as I played to much, but it looks like erosion.

THX my friend Mark to translate.

Very good!! That's how he should've looked!!

That looks really cool! I wish I could get into the sculpting part more..But, eh, no ideas there..Good job!

Are you the same person who did the Cybertron Unicron Mod?
BTW mind putting up some description to the WIP picture? Really feel like duplicating what you did but I'm too dumb to understand from picture alone.

that looks really really nice.

You talk this? →Unicron

Because my english is not good, it has no description

I will try to add some description later,

thanks for your suggestion ^^

Yeap that's what I was talking about, another superb piece!
è€�大，你写中文我也看得懂啊ï¼�想问问你到底是如何上色的ï¼
�以教教我�？

[/quote]

Yeap that's what I was talking about, another superb piece!
è€�大，你写中文我也看得懂啊ï¼�想问问你到底是如何上色的ï¼
�以教教我�？
[/quote]

我是用筆塗的呢! �料是用郡�油性油, �次都薄薄順一個方�油上, �點是乾了��油下一層, 直至將底色完全蓋上就�以了!